-
Elgato WAVE POP FILTER
Weight: 30 g / 1 oz
Dimension: 67 x 55 x 104 mm / 2.64 x 2.17 x 4.09 in
Material: Steel Mesh, ABS
In the box: Wave Pop Filter, Quick Start Guide
Wave Pop Filter features dual-layer steel mesh for optimum air current diffusion, so you can say your p’s and b’s without distortion.
-
Elgato Wave DX
Cardioid POLAR PATTERN
Dynamic Capsule
50-15000 Hz Frequency Response
2.5 mV/Pa, -52 dbV/Pa Sensitivity
600 Ohm Impedance
5/8" mount with 3/8" and 1/4" thread adapters included
3-pin XLR Connector
Inside the box:
Wave DX
3/8" and 1/4" Thread Adapters
Swivel Mount
Quick Start Guide -
WAVE XLR
MULTIFUNCTIONAL CONTROL DIAL
CAPACITIVE SENSOR
SWITCHABLE LOW-CUT FILTERS
MULTI-CHANNEL COMMAND
20 Hz - 20 kHz FREQUENCY RESPONSE
100 dB (120 dB Clipguard engaged) DYNAMIC RANGE
-130 dBV @ 60 dB gain EQUIVALENT INPUT NOISE (EIN)
0 - 75 dB GAIN RANGE
48 VDC, 7mA PHANTOM POWER
MAXIMUM INPUT LEVEL 10V @ 0dB gain(Clipguard engaged)
77 mW MAXIMUM OUTPUT LEVEL
24-bit RESOLUTION
48 / 96 kHz SAMPLE RATE
USB-C INTERFACE
IN THE BOXWave XLR, USB-C Cable (250 cm / 98.4 in), Quick Start Guide
-
Elgato Wall Mount
BALL HEAD: 1/4″ screw
LENGTH: Ca. 16.6cm / 6.53 in
MAXIMUM LOAD: 1.5 kg / 3.5 lbs
MATERIALS: Metal, Hard Composite
WALL PLATE: Mounting screws depend on wall conditions and are therefore not included
In the Box
1x Pole (ca. 8 cm / 3.15 in)
1x Ball Joint
1x Ball Head with 1/4" Screw
1x Wall Plate -
Elgato Wave Shock Mount
WEIGHT: 190 g / 6.7 oz (Adapters: 16 g / 0.6 oz)
DIMENSIONS: 115 x 135 x 32 mm / 4.53 x 5.31 x 1.26 in
MATERIALS: Steel, Rubber, Glass Fiber Reinforced Polymer
IN THE BOX: Wave Shock Mount (5/8" Thread), 3/8" and 1/4" Adapters, Quick Start Guide
Wave Shock Mount isolates your Wave microphone from handling, impact and surface noise, so you can capture clear rumble-free audio with confidence.